Rice Lake Sartorius Midrics 1 and 2 Series - Operating Instructions - Manual (Page 84)

GMP-compliant Printouts
When the corresponding menu item is
active, the measured result is bracketed
on the printout by a GMP header and
a GMP footer (GMP = “Good Manufactur-
ing Practice").
The GMP header precedes the first
measured result. The GMP footer is printed
either after each measured result
(“ISO/GLP/GMP: For 1 application result,"
menu item
7.11.2 ), or after the last result
in a series of measurements
(“ISO/GMP/GLP: For several application
results," menu item
7.11.3 ). To end a
series of measured results, press and hold
the p key (> 2 seconds). In this case,
the A symbol is displayed after the
GMP header is printed and remains in the
display until the GMP footer is printed.
A GMP-compliant printout is generated
automatically at the conclusion of
calibration/adjustment routines, as well as
when you set or clear a preload.
If you use a label printer for GMP-
compliant printouts and menu item
7.11.3
is active, the header and footer are printed
on two different labels. To generate
GMP-compliant printouts on labels, select
menu item
7.11.2 .
Examples of GMP headers and
one example of a footer are shown
in the following.
Weighing platform WP1:
--------------------
Dotted line
14.01.2007 09:43 Date and time 1)
Typ MW1P1 Midrics model
Ser.no. 12345678 Midrics serial no.
Vers. 1.1007.12.1 Software release for application
BVers. 01-25-01 Software release for basic version
-------------------- Dotted line
GMP footer:
-------------------- Dotted line
14.01.2007 09:45 Date and time 1)
Name: Field for operator signature
Blank line
-------------------- Dotted line
1) Interface YDO01M-332CLK (Option A31) required
84