Alarm recording connections, Terminal connections – Panasonic AG-DTL1P User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Terminal connections
As shown below, firmly twist the end of the cord which
is to be connected to the terminal section.
Firmly twist or
solder here.
Solid wire : 0.4 to 1.2 mm diameter
Twisted wire : 0.3 to 1.25 mm
(The diameter of the strands must be
0.18 mm or more.)
When connecting or disconnecting the
cord, press this part down using a
regular screwdriver.
Failure to twist the end of the cord firmly can cause
short-circuiting.
Alarm recording connections
Alarm switch 1
When an alarm signal is input to
ALARM INI, alarm recording or
sensor recording is performed.
V..
Alarm switch 2
When an alarm signal is input to
ALARM IN 2, alarm recording or
sensor recording is performed.
.../
• When alarm recording has been set for MODE on
the menu screen shown on P4 ALARM/SENSOR
REC, alarm recording is started when the alarm
switch is set to ON.
• Alarm recording is released when the alarm reset
switch is set to ON.
35