Panasonic AG-DTL1P - Manual (Page 89)

RS-232C
Query control commands
Data transmitted by PC Data returned from unit in response Description of command
[STX] QiR [ETX] [STX] LUlmdata [ETX]
Parameter
m = R: READ OK
E: READ NG
data = U7U6UsU4U7U3U2UiUo
The user ID is returned as an 8-
character ASCil code.
Binary 4BIT x8
♦
ASCII code; 0—9, A—F
Queries the user ID recorded on the playback tape.
[STX] QIW [ETX] [STX] LIWabcdefgh:ijklmnop [ETX]
Parameter
a—p = 1—8: Program registration
number (PGM1—PGM8)
F; Timer is not set.
Queries the weekly timer and daily timer setting.
a = Program 1 on
b = Program 1 on
c = Program 1 on
d = Program 1 on
e = Program 1 on
f = Program 1 on
g = Program 1 on
h = Daily program
i = Program 2 on
j - Program 2 on
k = Program 2 on
I = Program 2 on
m = Program 2 on
n = Program 2 on
0 = Program 2 on
p= Daily program
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
1
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
2
[STX] QLA:m [ETX]
Parameter
m = 1: Operation mode
D; Time setting
[STX] LAmn [ETX]
Parameter
m = I: Operation mode
Queries the operation mode that is to be established when
an alarm signal has been input at the tape-end position, and
the duration of the alarm recording and/or sensor recording.
n = S: STOP
Stop mode at tape-end
position
C: CONTINUE
Alarm signal input is
ignored.
m = D: Time setting
n = 0: 30 seconds
1: 1 minute
2: 1 minute and 30 seconds
3: 2 minutes
4: 3 minutes
5: 6 minutes
6: 10 minutes
7: CONTINUE
Recording continues until
the tape-end.
MANUAL
Recording is performed only
while an alarm signal is
input.
8 :
89