Panasonic AG-DTL1P - Manual (Page 60)

RS-232C
Time lapse control commands
Data transmitted by PC Data returned from unit in response Description of command
[STX] LRI:m [ETX] [STX] LRI [ETX]
Sets alarm recording or sensor recording to be performed if
an alarm signal has been input while repeat recording is
underway or while the tape is being rewound.
[STX] LRM:m [ETX] [STX] LRM [ETX] Sets the timer recording mode.
[STX] LRR;m [ETX] [STX] LRR [ETX] Sets REC REVIEW.
[STX] LSQ:m:t [ETX] [STX] LSQ [ETX] Sets the camera number and sequence mode.
[STX] LST:data1 :data2 [ETX] [STX] LST [ETX]
Sets the start date/time and end date/time for daylight
saving.
[STX] LSU:m [ETX] [STX] LSU [ETX] Turns daylight saving setting ON or OFF.
[STX] LTM;m [ETX] [STX] LTM [ETX] Sets the recording time mode.
[STX] LTY:n:t:abcdefgh [ETX] [STX] LTY [ETX]
Sets the combination of the recording time mode and
number of cameras.
[STX] LUl:data [ETX] [STX] LUI [ETX] Sets the recording user ID.
[STX] LWB:m [ETX] [STX] LWB [ETX] Sets the buzzer operation during auto OFF.
[STX] LWR [ETX] [STX] LWR [ETX] Deletes the POWER LOSS MEMORY data.
[STX] LXT;m [ETX] [STX] LXT [ETX]
Sets whether to acknowledge the input of the external timer
signals.
60