Panasonic AG-DTL1P - Manual (Page 49)

Setting menus
Menu page P7
[TERMINAL INPUT SELECT! P7
EXT TIMER IN OFF
TIME ADJUST IN 9:00
[TERMINAL OUTPUT SELECT!
ALARM/SENSOR OUT CONTINUE
ERROR WARN/REC OUT WARNING
EXT TIMER OUT START 0:00
END 0:00
[VIDEO OUT SEQUENCE]
SW INTERVAL 2s
BYPASS CAMERA OFF
BLACK MATTE OFF
LL CAMERA OFF
[EXT SWITCHER]
MODE VIDEO OUT
VIDEO OUT SEQUENCE screen
Menu item Description of function
SW INTERVAL For setting the timing at which the video signals which are supplied
from the camera and which are to be output from the rear panel
VIDEO OUT connector are to be switched.
Is (1 sec.), 1.5s (1.5 sec.), 2s (2 sec.), 2.5s (2.5 sec.), 3s (3 sec.),
4s (4 sec.), 5s (5 sec.), 10s (10 sec.)
BYPASS CAMERA For setting whether the video signals of a specific camera are not to
be output from the VIDEO OUT connector.
OFF : The video signals of all the cameras are output.
Cl—C16: The video signals of the specified camera/s are not
output.
BLACK MATTE For setting the processing of the black burst signal when switching
the video signals which are output from the video signal output
connector.
ON : The black burst signal is instantly output when the video signal
is switched.
OFF: The black burst signal is not output when the video signal is
switched.
LL CAMERA For setting the synchronization system of the connected cameras.
ON : Line-lock type of cameras
OFF: Internal sync and external sync type of cameras
<Notes>
• Use of the internal sync type of cameras is recommended.
• Select the ON setting when even one line-lock type of camera is
used.
The underlining indicates the factory mode setting.
EXT SWITCHER screen
Menu item Description of function
MODE For switching the function of the EXT SW INA/IDEO OUT connector
on the rear panel.
VIDEO OUT: The connector is used to outout the video sianals.
EXT SW IN : The connector is used to input the signals of the
external sequential switcher.
The underlining indicates the factory mode setting.
49