A&D Weighing AD-4406 - Manual (Page 34)

Page 32 AD-4406 Weighing Indicator
9. 9. 9. 9.
Accumulation
Accumulation Accumulation Accumulation
The function accumulates weight data and stores the total data and the
accumulation count. Data is stored in non-volatile memory, and is not lost even if
power is turned off.
9.1. Preparation and Specification
Set the following parameters to use the accumulation function.
Select CF08 1 for the CF-function so that the accumulation function becomes effective.
Specify the method of accumulation and data at F20 of the F-function.
Specify the inhibit region for accumulation at F21 of the F-function.
Selection of Accumulation Mode, F20 of the F-function
There are two methods of accumulation; manual accumulation using the key
assigned to operate the M+ function and automatic accumulation.
The accumulated data can select "positive data only" or "both polarity data".
The accumulated data can select "result of comparison is OK only" or "all result".
Accumulation Condition, F21 of the F-function
In case of manual accumulation mode, press the key to accumulate weight data
when the STABLE mark is displayed.
Data can be accumulated after the weight data enters the "inhibit region for output".
When connecting the power cord and turning the display on, the accumulation mode
takes the same action.
Inhibit region for accumulation F21 Description
Add data anytime F21 0 Stable data can be used anytime.
Above 5 d F21 1 Initial setting
Above 10 d F21 2
Above 20 d F21 3
Above 50 d F21 4
Caution Do not set F21=0 for the automatic accumulation mode.
If setting F21=0, it may add the same data two times or more.
Limitation of Accumulation Count and Total
The limitation of accumulation count is 999999.
The limitation of total is 999999, ignoring the decimal point.
If exceeding these limitations, the data is not accumulated.
Example: Setting the decimal point to "0.0", the limitation is "99999.9".
9. Accumulation