Comtrol ES7510 - Manual (Page 103)

RocketLinx ES7510 User Guide: 2000544 Rev. B Security - 103
Configuration Using the Web Interface
Security
The ES7510 provides several security features for you to secure your connection. The following pages are
included in this group:
• Port Security on Page 103
• IP Security on Page 104
• 802.1x Configuration on Page 105
• 802.1x Port Configuration on Page 106
• 802.1x Port Status on Page 108
Optionally, you can use the CLI for configuration, see Security (CLI) on Page 170.
Port Security
The Port Security page allows you to stop the MAC
address learning for specific port. After stopping MAC
learning, only the MAC address listed in Port Security
List can access the switch and transmit/receive traffic.
You can restrict what devices can access the management
features of the ES7510. MAC addresses added to the
static MAC address table can be authorized to access
specified ports on the switch.
When Port Security is enabled on any port, only
authorized MAC addresses are able to access the
management features of the ES7510 on enabled ports.
Ports with security disabled block all attempts to access
the ES7510’s management features. To globally disable
port security you must disable the feature on each
individual port.
The Port Security page allows you to enable Port Security and configure Port Security entry.
Port Security Page
Port Security State Select Enable to change the state of the Port Security State for this port.
Apply
Click Apply to apply the settings.
Note: You must Save the settings ( Page 122 ), if you want to maintain these
settings if the ES7510 is powered off.
Add Port Security
Entry
Select the port, and enter the VID and MAC address.
The format of the MAC address is xxxx.xxxx.xxxx, for example: 00c0.4e2D.0101.
The maximum volume of one port is 10. The system can accept a total of 100 Port
Security MAC addresses.
Add Adds a port security entry.
Port Security List This table shows you enabled port security entries.
Remove Removes the selected port security entry.