Dscp-queue mapping – Comtrol ES7510 User Manual
Page 95
RocketLinx ES7510 User Guide: 2000544 Rev. B
DSCP-Queue Mapping - 95
Configuration Using the Web Interface
(PHB) decisions about packet classification and traffic conditioning functions, such as; metering, marking,
shaping, and policing.
After configuration, press Apply to enable the settings.
Note: You must Save the settings (
), if you want to maintain these settings if the ES7510 is powered
off.
DSCP-Queue Mapping
Use this page to change DSCP values to Physical Queue mapping table. Since the switch fabric of the ES7510
only supports four queues. Lowest, Low, Middle and High users should therefore assign how to map DSCP
values to the level of the physical queue. You should therefore assign how to map DSCP value to the level of
the queue. You can change the mapping table to follow the upper layer 3 switch or routers’ DSCP setting.
After configuration, press Apply to enable the settings.
Note: You must Save the settings (
), if you want to maintain these settings if the ES7510 is powered
off.