Comtrol ES7510 - Manual (Page 177)

RocketLinx ES7510 User Guide: 2000544 Rev. B Monitor and Diag (CLI) - 177
Configuration Using the Command Line Interface (CLI)
Port Mirroring (continued)
Display
Switch# show mirror
Mirror Status : Enabled
Ingress Monitor Destination Port : fa6
Egress Monitor Destination Port : fa6
Ingress Source Ports :fa1,fa2,
Egress Source Ports :fa1,fa2,
Event Log
Display
Switch# show event-log
<1>Jan 1 02:50:47 snmpd[101]: Event: Link 4 Down.
<2>Jan 1 02:50:50 snmpd[101]: Event: Link 5 Up.
<3>Jan 1 02:50:51 snmpd[101]: Event: Link 5 Down.
<4>Jan 1 02:50:53 snmpd[101]: Event: Link 4 Up.
Topology Discovery (LLDP)
Enable LLDP
Switch(config)# lldp
holdtime Specify the holdtime of LLDP in seconds
run Enable LLDP
timer Set the transmission frequency of LLDP in seconds
Switch(config)# lldp run
LLDP is enabled!
Change LLDP
timer
Switch(config)# lldp holdtime
<10-255> Valid range is 10~255
Switch(config)# lldp timer
<5-254> Valid range is 5~254
Ping
Ping IP
Switch# ping 192.168.11.14
PING 192.168.11.14 (192.168.11.14): 56 data bytes
64 bytes from 192.168.11.14: icmp_seq=0 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=1 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=2 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=3 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=4 ttl=128 time=0.0 ms
--- 192.168.11.14 ping statistics ---
packets transmitted, 5 packets received, 0% packet loss
round-trip min/avg/max = 1.3/1.3/1.4 ms