Comtrol ES7510 - Manual (Page 57)

RocketLinx ES7510 User Guide: 2000544 Rev. B Factory Defaults - 57
Configuration Using the Web Interface
Factory Defaults
You can reset all the configurations of the switch to default settings.
Click Reset, if you want the ES7510
to reset all configurations to factory
default settings.
The system displays a popup
message window after finishing. The
default settings work after rebooting
the ES7510.
Click Yes in the popup alert screen to
reset the configuration to the factory
defaults.
The following popup message screen shows you that
the ES7510 has been reset to factory defaults. Click OK
to close the screen and then go to the Reboot page to
reboot the switch.
Click OK. The system automatically reboots the
ES7510.
Note: If you have already configured the IP of the
ES7510 to another IP address, when you use this procedure, the software does not reset the IP address to
the default IP address. The ES7510 IP address does not change so that you can still connect the switch
through the network.
System Reboot
System Reboot allows you to reboot the device. Some of the
feature changes require you to reboot the system. Click Reboot to
reboot your ES7510.
Note: Before rebooting, remember to click Save to save your
settings. Otherwise, the settings you are lost when the
ES7510 is powered off.
Click Yes. The switch reboots immediately.
Click Ok so that the ES7510 reboots.