LAARS NeoTherm NTV1000 - Install and Operating Manual - Manual (Page 42)

LAARS Heating Systems
Page 38
fig. 32 - Status Summary Screen Showing
Pumps Information
Notice the four buttons at the bottom of each
Status Summary screen:
• Configure – Allows an installer to change
some of the setup parameters used by the
system. A password may be required.
• Operation – Used to adjust the setpoints,
change the fan speed, turn a burner on or
off, or turn the pumps on or off.
• Diagnostics – Allows you to run diagnostic
tests, or check the inputs and outputs used
by the system.
• Details – Allows you to check the status of
all of the setup parameters on the control
system.
In the version of the Status Summary screen
shown in Fig. 32, Pumps has been selected
(as shown by the label on the left side of the
screen), and the indicators below show the
status of each of the pumps. Red = off and
green = on.
If you press the Question-Mark symbol, the
system will present more information about
the pumps.
3. You can also press the button for Modulation
(on the right side of the screen) to bring
up another version of this screen showing
modulation information. See Fig. 33.
fig. 33 - Status Summary Screen Showing
modulation Information
4. Press the button for Setpoints to bring up a
screen that lists the setpoints. See Fig. 34.
fig. 34 - Status Summary Screen Showing
Setpoints
8.6 Checking Individual Details
The Details button on the Status Summary screen
leads to a series of screens that show all of the setup
parameters entered for the controller you have selected.
Let’s say that the first screen presented in this series is
the screen for Frost Protection. See Fig. 35.