LAARS NeoTherm NTV1000 - Install and Operating Manual - Manual (Page 46)

LAARS Heating Systems
Page 42
fig. 43 - reset Button on Controller
3. Don’t press the Reset button yet. We just want
to show you where the Reset button is located.
Change the parameter(s) you want to change.
4. When you are done entering parameters, the
next job is to do the verification. Login to the
system and press Begin.
fig. 44 - edit Safety Data
5. Once you are done changing safety
parameters, press Confirm. The system will
present a listing for each group of parameters
which includes a changed safety parameter.
See Fig. 45.
Fig. 45 - Safety Parameter Confirmation
6. For each group, check the list carefully. Press
Yes if all of the parameters in the group have
been entered correctly.
If you made changes in other safety-related
groups, verify the entries in those groups in
the same way. When the process is complete,
the system will tell you to reset the control
system.
fig. 46 - Safety Parameter reset
7. As we said, the Reset button is located on the
front of the controller. See Fig. 43. You must
press the Reset button within 30 seconds, or
the verification will be cancelled.