Cino FA470 - Manual (Page 136)

Command Descriptions
2-121
Reply SE Operation
(SE)
Descriptions
Reply the desired one or more parameters of the Operation Settings for Scan Engine
Reply SE Operation is sent by the device in response to the Get SE Operation command. It sends
the values for all the desired parameters requested in the Get SE Operation command.
Available for SE380, SE390 & SE480 series
Packet Format
Prefix Opcode Status Length Parameter(s) LRC Suffix
7Eh 0Ah 00h 00h 00h Variable See Below Variable 7Eh
1 Byte 3 Bytes 1 Byte 2 Bytes Variable 1 Byte 1 Byte
Parameter(s)
First Parameter ……… Last Parameter
PID Size Options ……… PID Size Options
2 Bytes 2 Bytes Variable ……… 2 Bytes 2 Bytes Variable
See Next Page
. Host Requirements
Since Reply SE Operation is a device-to-host message, there is no response for this message.
. Parameter(s) Field
Set SE Operation can change multiple parameters at one time, so it takes compound parameters.
. Length
Total size (bytes) of the Parameter(s) field
. LRC
”Opcode” XOR “Status” XOR “Length” XOR “Parameter(s)”
. Size
Total size (bytes) of the Options field