Cino FA470 - Manual (Page 45)

Command Descriptions
2-30
SE Operation Mode
(SE)
Descriptions
Select operation mode for Scan Engine
SE Operation Mode is equivalent to the Operation Mode Selection in the Set SE Operation
command. It is of more convenience to use SE Operation Mode of the Action Command Category.
Available for SE380, SE390 & SE480 series
Packet Format
Prefix Opcode Status Length Parameter(s) LRC Suffix
7Eh 80h 08h 04h 00h 00h 01h See Below Variable 7Eh
1 Byte 3 Bytes 1 Byte 2 Bytes 1 Byte 1 Byte 1 Byte
. Host Requirements
If the device successfully received the above command issued by the host, a “Device ACK” will be sent
to the host right after the device performed the action. Otherwise, a “Device NAK” will be sent to host to
issue a command error. However, if the host can not receive any response from the device within the
user preset time-out duration, please resend the above command.
. Length
Total size (bytes) of the Parameter(s) field
. LRC
”Opcode” XOR “Status” XOR “Length” XOR “Parameter(s)”
Parameter(s)
< Table 4-4 > SE Operation Mode Parameter(s) Field
Parameter / PID / Size Options Descriptions
SE Operation Mode
PID : <Null>
Size : 00h 01h (1 Byte)
- 00h
- 01h
- 02h
- 04h
- 06h
- 09h
Trigger mode (External triggering) *
Force mode (Continued power on)
(See Note)
Presentation mode (Auto Detection)
Level mode (Auto power off)
Alternative mode (Periodic power off)
Low Power mode (Low Power triggering)
. Notes
Force mode is not available for SE390 and SE480 series.