Tascam X-48 - Manual (Page 4)


Rack-mounting the Unit
Use the supplied rack-mounting kit to mount the unit in a
standard 19-inch rack, as shown below.
Remove the feet of the unit before mounting.
NOTE
Leave 1U of space above the unit for ventilation.
Allow at least 10 cm (4 in) at the rear of the unit for
ventilation. •
•
This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified as
a class 1 laser product. There is no hazardous invis-
ible laser radiation during operation because invis-
ible laser radiation emitted inside of this product is
completely confined in the protective housings.
The label required in this regulation is shown at 1.
Optical pickup:
Type:
SF-DS10L
Manufacturer: SANYO
Laser output: 108 mW max (CD), 66 mW max (DVD)
Wavelength: 782 nm (CD), 658nm (DVD
CAUTION
• DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
• USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
• IF THIS PRODUCT DEVELOPS TROUBLE,
CONTACT YOUR NEAREST QUALIFIED SERVICE
PERSONNEL, AND DO NOT USE THE PRODUCT
IN ITS DAMAGED STATE.
CERTIFICATION
COMPLIES WITH 21 CFR
1040, 10 AND 1040, 11 EXCEPT FOR DEVIATIONS PURSUANT
TO LASER NOTICE NO. 50, DATED JULY 26, 2001.
MANUFACTURED
TEAC CORPORATION
3-7-3 NAKA-CHO, MUSASHINO-SHI, TOKYO, JAPAN
Safety Information