Using markers, Loop playback, Loop mode – Tascam X-48 User Manual
Page 41: Recorder
Recorder
•
Select Meter Mode and press the CHNG button to switch between Pre-Fader
(the default) and Post-Fader.
• Select
Meter Range
and press the CHNG button to switch between -oo to
0dB
(minus infinity to 0dB, the default) -24dB to 0dB or -12dB to 0dB.
These fine dB scales can be useful when sending test tones to the recorder, such as
for aligning the analog I/O card or a Dolby encoder.
• Select
Peak Hold
to switch this function on or off.
Using Markers
Markers allow you to label sections of a recording for visual reference and to locate back to
later.
Mouse/Keyboard Operation
•
To create a marker, click the Edit menu and select New Marker or press the Enter
key on your keyboard's number pad.
•
To access a memory location, open the Markers window from the Windows menu.
From here you can select a memory location, rename it and locate to it.
Loop Playback
You can loop a section of the timeline for playback or recording. The loop plays back (with
preroll and postroll settings, if assigned) until the stop button is pressed.
Mouse/Keyboard Operation
•
Drag the loop start and stop points to the location you want them. The loop markers
are blue triangles that fill the entire height of the timeline ruler, and are at 0:00:00:00
by default.
•
Click the loop button
to turn on the loop function.
•
Press Play.
Loop Mode
The X-48 has three Loop Modes:
•
Play Once and Cue plays through the loop once, then locates to the beginning of the
loop (or pre-roll point if enabled) and stops.
•
Play Once and Stop plays through the loop once and then stops at the loop end (or
post-roll point if enabled).
•
Play Repeatedly plays through the loop, locates to the beginning of the loop (or
preroll point if enabled) and plays again, repeating until the stop button is pressed.
By default,
the Loop mode is set to Play Once and Cue. To change this behavior:
41