Setting up the wan connection – ARRIS TR3300-AC Users Guide User Manual
Page 22
Chapter 5: Basic Configuration
Release 33 STANDARD 1.5 February 2015
TR3300-AC 802.11ac Wireless Router User Guide 22
Setting Up the WAN Connection
A Dynamic or DHCP (Dynamic Host Configuration Protocol) connection is the most
commonly used WAN connection type.
Note: Do not change this setting unless your Internet Service Provider tells you to use
another connection type.
Perform the following steps to change the connection type.
1. Access and log into the configuration interface.
2. Click the WAN Setup tab.
3. Click Dynamic, Static, Dynamic (IPV6),or Static (IPV6) in the side menu to
display the appropriate screen for configuring that type of WAN connection.
4. Set the required configuration parameters for the connection type you selected as
provided by your service provider.
Note: Refer to WAN Setup in
Wireless Router Configuration Screen Descriptions
(page 29)
for specific instructions on setting the various connection type configuration parameters.
5. Click Apply at the bottom of the screen.