ARRIS TR3300-AC Users Guide - Manual (Page 38)

Chapter 7: Wireless Router Configuration Screen Descriptions
Release 33 STANDARD 1.5 February 2015 TR3300-AC 802.11ac Wireless Router User Guide 38
Without DHCP, the IP addresses must be entered manually at each computer in an
organization, and a new IP address must be entered each time a computer moves to a new
location on the network.
Start IP Address (IPV6)/End IP Address (IPV6) – Enter the range of IPV6 addresses that
the DHCP Server will be allowed to assign to a network device.
Lease Time V6 – Enter the lease time in seconds before the assigned IPV6 address will
expire. (After the lease time is up, the user is automatically assigned a new dynamic IP
address.)
A "lease" is the amount of time that a given IP address will be valid for a computer or other
network device. The lease time can vary depending on how long a user is likely to require
the Internet connection at a particular location. Using very short leases, DHCP can
dynamically reconfigure networks where there are more computers than available IP
addresses, such as educational environments.
DHCP Relay Settings (IPV6):
Enable DHCP Relay (IPV6) – Click this checkbox to enable DHCP Relay functionality on
the system.
Client List
This page shows the host name, IP address, and MAC address of each computer that is
connected to the network. If a computer does not have a specified host name, then the
host name field will be blank.
Note: You can optionally set up the system so that there is more than one LAN in the
network. This is most useful for commercial applications not home use. All of the "LAN Setup" and
"Wireless Setup" configuration parameters can be set independently for each individual LAN.
Static Client List:
Click Add to create a new fixed client lease.