ARRIS TR3300-AC Users Guide - Manual (Page 7)

Release 33 STANDARD 1.5 February 2015 TR3300-AC 802.11ac Wireless Router User Guide 7
Chapter 2
Safety Requirements
The ARRIS TR3300-AC Wireless Router complies with the applicable requirements for
performance, construction, labeling, and information when used as outlined below:

Do not use product near water (i.e. wet basement, bathtub, sink or near a swimming
pool, etc.), to avoid risk of electrocution.

The product shall be cleaned using only a damp, lint-free, cloth. No solvents or
cleaning agents shall be used.

Do not use spray cleaners or aerosols on the Wireless Router.

Avoid using and/or connecting the equipment during an electrical storm, to avoid risk
of electrocution.

Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition source (i.e. heat
registers, space heaters, fireplaces, etc.).

Use only power supply and power cord included with the equipment.

Equipment should be installed near the power outlet and should be easily accessible.

In areas of high surge events or poor grounding situations and areas prone to lightning
strikes, additional surge protection may be required (i.e. PF11VNT3 from American
Power Conversion) on the AC and Ethernet lines.

When the Wireless Router is connected to a local computer through Ethernet cables,
the computer must be properly grounded to the building/residence AC ground
network. All plug-in cards within the computer must be properly installed and
grounded to the computer frame per the manufacturer’s specifications.

Ensure proper ventilation. Position the Wireless Router so that air flows freely around
it and the ventilation holes on the unit are not blocked.

Do not mount the Wireless Router on surfaces that are sensitive to heat and/or which
may be damaged by the heat generated by the modem, its power supply, or other
accessories.
FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B
digital device under Part 15 of the Federal Communications Commission (FCC) rules.
These requirements are intended to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures: