Cadac R-Type - Manual (Page 127)

GLOSSARY-IX
Revision R2005-2 R-Type
one Mute Group and can be muted by pressing
one button.
Mute group assignments The process of assigning channels to one mute
group i.e. all channels in that group may then be
muted by pressing only one button.
NF Abbreviation of Note OFF - this term relates to
MIDI-functions that are controlled by CADAC’s
software package for console automation
(Sound Automation Manager).
NO Abbreviation of Note ON - this term relates to
MIDI-functions that are controlled by CADAC’s
software package for console automation
(Sound Automation Manager).
O/P Abbreviation of OutPut.
O/P to MTX Feature of the Mono Input channel module
allowing direct routing to matrix busses 13-16
from POST fader (with or without stereo pan-
ning).
on-board jumpers Inter-connects that may be configured by the
user to suit a certain application.
OPEN LED Located on a fader panel, this LED illuminates
when the channel VCA is open and not muted
locally or by assignment to a Mute Group.
Osc frequency Feature of the Oscillator & Communications
module allowing the integral module oscillator to
be set to generate a certain frequency within the
range of 31Hz to 16kHz, as indicated by the
switch.
oscillator An electronic circuit used to generate a single
frequency or noise spectrum.
Oscillator/Comms module Module that features an oscillator, remote calling
and communication functions.
Out-of-phase signal A signal is said to be out-of-phase if the positive
and negative parts of the waveform are opposed
to the positive and the negative parts of a
source waveform to which it is being compared.
Output to Matrix Feature of the Mono Input channel module
allowing direct routing to matrix busses 13-16
from POST fader (with or without stereo pan-
ning).
override Bypass or cancel a function.
P&N Abbreviation of Previous & Next. Refers to the
associated buttons on the CCM . Press P to
back to the previous scene or N to go to the
Next scene.
pad Electronic circuit that attenuates an input signal
to allow for a line-level source to be connected
to a microphone input.
PAN Control The control pans the post-fade signal from Left
through Centre to Right on the LCR module
master outputs. In L-R mode, the control pans
the post-fade signal from Left through Right on
the LCR module master outputs without affect-
ing the centre sends.