Cadac R-Type - Manual (Page 35)

How to use the R-Type 4-7
Revision R2005-2 R-Type
■ ■ ■ ■ Press the PFL buttons on the selected input channels which will add the PFL-
signals together.
71;16 +RZ#WR#DSSO\#/LVWHQ#WR#DQ#RXWSXW
■ ■ ■ ■ Press the Listen button on the selected sub output module
■ ■ ■ ■ Ensure the Listen switch on the Listen module is pressed
■ ■ ■ ■ Ensure level is up on Master faders for monitoring through speakers.
The signal to feed the monitor amplifier is taken from the Listen output on the rear of
the Listen module.To monitor via headphones, select PFL next to the headphone
level control.
71;17 +RZ#WR#DSSO\#/LVWHQ#WR#D#JURXS#RI#RXWSXWV
■ ■ ■ ■ Press PFL/LIsten output HOLD on the FCM
■ ■ ■ ■ Press the Listen buttons on the selected output channels, which will add the sig-
nals together.
71< +RZ#WR#RSHUDWH#+2/'2&+$11(/#35,25,7<2
&/($5#)#7$/.%$&.#72#/,67(1
71<14 )&0#3)/2/,67(1#+2/'#LV#2))
This mode provides INTERCANCEL - which cancels any active PFLs or Listen sig-
nals when a new signal is selected. Note that even if INTERCANCEL mode is active,
pressing a PFL or Listen button, while at the same time holding down any of these
buttons on another module, will cause the signals to mix.
71<15 )&0#3)/2/,67(1#+2/'#LV#21
This mode provides an ADDITIVE function, which mixes each new PFL or Listen sig-
nal with the previous signal.
71<16 &+$11(/#35,25,7<
Selecting Channel Priority mode causes an input PFL to override an output Listen,
but will not cancel it.
71<17 )&0#&/($5
The CLEAR buttons will, in any mode, illuminate if a PFL or Listen is active and can
be used to cancel the current selection. The CLEAR buttons will also illuminate when
the Listen buttons are selected on the T/B module, in which case the CLEAR button
will have no effect.
71<18 &+$11(/#3)/#WR#$)/
This function converts all channel PFL buttons to AFL. Left and Right signal are
routed in stereo to the Listen module.