20 eq pre ins, 21 equalizer in, 22 hp filter in – Cadac R-Type User Manual
Page 72: 23 hp filter frequency control, 24 pan left - centre - right, 25 centre switch, 26 pan centre level, 27 left - right switch
8-6
Stereo Input Channel 8231
R-Type
Revision R2005-2
;14153 (4#35(#,16
In normal operation the equalizer is situated after the channel INSERT. Press this
button to put the EQ before the channel INSERT.
;14154 (TXDOL]HU#,1
Press this button to switch the Equalizer in circuit.
;14155 +3#)LOWHU#,1
Press this button to switch the HP-filter in circuit. Note that the HPF is situated imme-
diately after the MIC-amp and is not switched with the equalizer.
;14156 +3#)LOWHU#)UHTXHQF\#FRQWURO
This is a variable control for selecting the frequency at which the filter starts to “turn
over” (also known as the knee or -3dB point for the filter). The “turn-over” frequency
is continuously variable between 14 and 400 Hz and provides a cut of 12dB/oct (2nd
order
;14157 3$1#/HIW#0#&HQWUH#0#5LJKW
When selected, this switch overrides selection of the Centre and L-R switches. This
will route the input signal to the three main LCR outputs on the LCR module (see
) via the pan control. The PAN control then behaves in a true LCR
fashion, panning the post-fade signal from left through centre to the right outputs.
L-R and Stereo Bus
Jumper 33 sums the Left and Right input signal which then inputs to the PAN control
allowing a summed mono signal to be panned between Left and Right on the L-R
and Stereo busses.
Removing jumper 33 allows a true stereo signal to bypass the PAN control allowing
the Left signal to feed the left side of the L-R and Stereo bus only, and the Right sig-
nal to feed the right side of the L-R and Stereo bus only. (With this jumper removed
the PAN control will be inactive.)
;14158 &HQWUH#VZLWFK
Routes the post-fade signal directly to the centre output of the LCR module via the
Centre level control. If the LCR switch is activated, this switch is inactive.
;14159 3$1#&HQWUH#OHYHO
This control has 6dB in hand and is centre detented at 0dB. This control is used to
set the post-fade signal level to the centre output of the LCR module if the Centre-
switch is activated. This can be used to mix or balance signal levels when the centre
output is used as a separate mono bus in conjunction with the standard L-R bus. If
the LCR switch is activated this control is inactive
;1415: /HIW#0#5LJKW#VZLWFK
Sends the post-fade signal to the main L-R outputs on the LCR module via the PAN
control, which behaves in a normal fashion, panning the signal between left and
right. See 8.1.28 PAN Control.