Cadac R-Type - Manual (Page 62)

7-8 Mono Input Channel 8241
R-Type Revision R2005-2
level control via the pan control to the aux/group outputs. These can be selected in
two banks of 8, sends 9 A & B to 12 A & B and/or 13 A & B to 16 A & B allowing for a
maximum of 16 (8stereo) traditional subgroups.
See also
7.1.10 Sends 9A/B - 16A/B .
:14163 6WHUHR#3$1#WR#JURXSV#46#0#49
See 6.1.29 above.
:14164 3)/
Press the PFL button to send the pre-fader signal to the LISTEN module where it can
be checked on speakers or headphones. The PFL button is an electronically latching
switch which is controlled by the PFL/SOLO switches on the panel of the 8285 mod-
ule located beneath the CCM. The PFL-function can be globally changed on all
channels (mono and stereo) to function as AFL after fader and PAN, see
7.1.9 Out-
put to Matrix .
:14165 0DWUL[#46#0#49
If selected, this switch will route the direct to Matrix selection from the “O/P to MTX”
switches to the matrix outputs via the pan control, allowing matrix outputs 13/14 and/
or 15/16 to be used as further stereo outputs. See
7.1.9 Output to Matrix .
:14166 ,QVHUW
Press this switch to insert external equipment connected to the insert send and
return jack sockets on the rear panel of the module, see
7.2 Mono Input Channel
8241 - rear panel . Please note that the insert send is permanently live and that the
jack sockets are NOT normalized. The insert point can only be enabled by the front
panel button. Also note that it is possible to make the insert point post the equalizer
circuit by pressing EQ PRE INS, see
7.1.20 EQ PRE INS .
:14167 087(
Press this button to mute all POST-FADE signals from the Input channel except for
AFL send.