4 configuring the console system, 1 send bus settings, Configuring the console system -6 – Cadac R-Type User Manual
Page 46: 917 &rqiljxulqj#wkh#frqvroh#v\vwhp
6-6
Central Control Module 8281
R-Type
Revision R2005-2
PLAY/PAUSE (1) Plays, pauses or continues a recorded sequence of motor fader
movements associated with dynamic A. If recording is enabled with the push-button
(8), then this button starts either a new recording, or starts an update of an existing
dynamic.
PLAY/PAUSE (2) Plays, pauses or continues a recorded sequence of motor fader
movements associated with dynamic B.
STOP (3, 4) Stops the recorded sequence of motor fader movements.
SET READY (5) This mode allows individual faders to be “toggled” between safe and
ready mode by touching the fader knob.
ALL READY (6) Sets all motor faders to ready mode.
ALL SAFE (7) Sets all motor faders to safe mode.
RECORDING ENABLED (8) Prepares the computer for recording of a dynamic
sequence. Pressing button (1) starts the actual recording.
917
&RQILJXULQJ#WKH#FRQVROH#V\VWHP
Many aspects of the way the R-Type system performs may be set and changed by
the user. The settings are then held in the battery-backed memory.
91714
6HQG#%XV#VHWWLQJV
The first 8 pairs of send busses may be configured to be stereo or dual mono. The
choice is made as follows:
■
■
■
■
Press the SYS button
■
■
■
■
Use the up and down arrow buttons until the display reads USER SETUP
■
■
■
■
Press the return button
■
■
■
■
Use the up and down arrow buttons until the display reads BUS CONFIG
■
■
■
■
Press the return button
■
■
■
■
Use the up and down arrow buttons to select the required bus
■
■
■
■
Press the return button to toggle between mono or stereo
FIG 6-4. R-Type Central Control Module (lower
section)