Cadac R-Type - Manual (Page 74)

8-8 Stereo Input Channel 8231
R-Type Revision R2005-2
Removing jumper 33 allows a true stereo signal to bypass the PAN control allowing
the Left signal to feed the left side of the L-R and Stereo bus only, and the Right sig-
nal to feed the right side of the L-R and Stereo bus only. (With this jumper removed
the PAN control will be inactive.)
;14163 6WHUHR#3$1#WR#JURXSV#<#0#45
If selected, this switch will route the auxiliary/group send depending on internal
jumper settings from the aux/group send level control via the pan control to the aux/
group outputs. These can be selected in two banks of 8, sends 9 A & B to 12 A & B
and/or 13 A & B to 16 A & B allowing for a maximum of 16 (8stereo) traditional sub-
groups.
See also
7.1.10 Sends 9A/B - 16A/B .
Aux/Groups 9-16
Jumper 34 sums the Left and Right input signals which then input to Aux/Group
sends 9-16, allowing a summed mono signal to these Aux/Groups.
Removing jumper 24 AND enabling the “Stereo Pan to Grps” switch (located under
the pan control) allows a true stereo signal to input to the groups, that is the Left
input to feed the A send and the Right input to feed the B send.
;14164 6WHUHR#3$1#WR#JURXSV#46#0#49
See 7.1.30.
;14165 3)/
Press the PFL button to send the pre-fader signal to the LISTEN module where it can
be checked on speakers or headphones. The PFL button is an electronically latching
switch which is controlled by the PFL/Listen switches on the panel of the FCM
located beneath the CCM. The PFL-function can be globally changed on all chan-
nels (mono and stereo) to function as AFL after fader and PAN, see
7.1.9 Output to
Matrix .
;14166 0DWUL[#46#0#49
Regardless of jumper options, by default the odd number switches, 13 and 15 will
output the Left signal to the 13 and/or 15 matrix output and even numbered switches,
14 and 16 will send the Right signal to the 14 and/or 16 matrix output. Enabling the
“Mtx Stereo pan to” switch (located under the PAN control) will send a summed mono
signal to the Matrix outputs via the PAN control. (See 7.1.28 d) Direct to Matrix
switches.)
;14167 ,QVHUW
Press this switch to insert external equipment connected to the insert send and
return jack sockets on the rear panel of the module, see
7.2 Mono Input Channel
8241 - rear panel . Please note that the insert send is permanently live and that the
jack sockets are NOT normalized. The insert point can only be enabled by the front
panel button. Also note that it is possible to make the insert point post the equalizer
circuit by pressing EQ PRE INS, see
7.1.20 EQ PRE INS .
;14168 087(
Press this button to mute all POST-FADE signals from the Input channel except for
AFL send.