3 phase reverse, 4 pfl - l and r, 5 line-up tone – Cadac R-Type User Manual

Page 69: 6 48v phantom power, 7 -20db pad, 8 left + right, 9 output to matrix, 10 sends 9a/b - 16a/b, 11 sends 1a/b - 8a/b

Advertising
background image

Stereo Input Channel 8231

8-3

Revision R2005-2

R-Type

;1416

3KDVH#UHYHUVH#

These buttons enable you to reverse the phase of the incoming signals of the left and
right MIC amps independently or together.

;1417

3)/#0#/#DQG#5

Pressing this button enables you to monitor the left and right MIC amps via the PFL
system. Pressing L or R will send a mono signal to the left and right busses of the
Listen module. Pressing both buttons together will send a true stereo image to the
L & R of the PFL-bus.

;1418

/LQH0XS#WRQH

Press this button to apply a Line-up tone to the input. The frequency and level of the
line up tone applied is controlled from the OSC/Comms module 8271, see

11.1 Osc

& Communications 8271 - front panel.

Pressing this button will also disable the 48v

phantom power if selected, see 7.1.6.

;1419

7;9#SKDQWRP#SRZHU

Press this button to switch on the 48V Phantom power to any connected microphone.
Notice that the 48 v phantom power is disabled on this channel if the line-up tone is
selected (see 7.1.5).

;141:

053G%#3DG

Press this button to apply -20dB attenuation to the input signal to the L & R micro-
phone amplifiers. If the gain potentiometer (see

8.1.1 Input Gain LEFT/RIGHT

) is set

for 20dB and the pad applied, this allows for the use of line level (0dB nominal)
devices instead of having a separate line input.

;141;

/()7#.#5,*+7

Press this button to sum the LEFT and RIGHT MIC amp signals to MONO.

;141<

2XWSXW#WR#0DWUL[

These buttons are used to select direct routing to matrix busses 13 to 16 from POST
fader, with or without stereo panning. See

8.1.33 Matrix 13 - 16

and

8.1.28 PAN Con-

trol

.

;14143 6HQGV#<$2%#0#49$2%

Sends 9A/B - 16A/B are dedicated mono sends, each with its own level control. Each
pair has its own PRE/POST FADER and ON/OFF switch.

Sends 9A/B - 12A/B and 13A/B - 16A/B can be selected to follow the STEREO PAN-
NING by using the buttons in the panning section at the bottom of this module. See

8.1.28 PAN Control

,

8.1.30 Stereo PAN to groups 9 - 12

and

8.1.33 Matrix 13 - 16

.

;14144 6HQGV#4$2%#0#;$2%

Sends 1A/B - 8A/B can be switched between stereo and dual mono. In stereo, adjust
the level with the upper control and panning with the lower one. In dual mono, adjust

Advertising