Comtech EF Data SLM-5650A Vipersat - Manual (Page 35)

Chapter 2 - Quick Start Configuration 2-11
Initial Configuration
Multicast Routing with IGMP
For networks that will utilize the Vipersat IGMP (Internet Group Management
Protocol) feature for multicast routing, additional routing configuration is
required. See the section “Multicast Routing” on page 3-44.
Set the Satellite Modem Configuration
1. Select Config from the Modem submenu to access the Modem
Configuration page (figure 2-7).
2. Set the Transmit parameters for Frequency , Data Rate , FEC , Code Rate ,
and Modulation as specified by the network administrator.
Figure 2-7 Transmit Configuration Frame (Hub)
Note: Only Turbo Product Coding is acceptable for FEC when the SLM-5650A
is running in Vipersat mode. NOTE