Load switching, Load switching -30, Te (figure 3-33 – Comtech EF Data SLM-5650A Vipersat User Manual
Page 70
Vipersat Configuration
3-30
Vipersat SLM-5650A User Guide
Figure 3-33 Switching Page (Remote)
Load Switching
One of the four automatic switching functions that the Vipersat SLM-5650A is
able to perform is Load Switching. The system will detect variations in data rate
and can be configured to switch from STDMA to SCPC based on bandwidth
requirements.
The initial switch for a Remote SLM-5650A from STDMA mode to SCPC
mode is determined by the Hub Burst Controller. Once the Remote is switched
into SCPC, any requests to meet additional switching requirements within
SCPC (Step Up or Step Down) are made by the Remote modem.
The Load Switching feature for the SLM-5650A is Enabled and Disabled by
selecting the desired radial button at the top of the page.