Metro Mobile Computing Workstations MPE-7800 Series Nickel Metal Hydride Power Supply - Manual (Page 3)

Metro TM MPE-7800 Series NiMH Power Supply Operations Manual Supplement, Doc. No. L01-504 3
InterMetro Industries Corporation
Notice:
InterMetro Industries Corporation reserves the right to make improvements or changes in the products described in this manual at
any time without notice.
While reasonable efforts have been made in the preparation of this document to assure its accuracy, InterMetro Industries
Corporation assumes no liability resulting from any errors or omissions in this document, or from the use of the information
contained herein.
Copyright Notice:
This manual is copyrighted. All rights reserved. This manual may be printed for personal use only. This manual, whole or in part,
may not be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form for
distribution. This manual, whole or in part, may not be modified without prior consent, in writing, from InterMetro Industries
Corporation.
Copyright © 2013 by InterMetro Industries Corporation, 651 North Washington Street, Wilkes-Barre, PA 18705, U.S.A.
•
Metro is a registered trademark of InterMetro Industries Corporation.
• Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
Contact Information:
InterMetro Industries Corporation
North Washington Street
Wilkes-Barre, PA 18705
Phone: 1-800-992-1776
http://www.metro.com/support
FCC Information:
This device complies with FCC Rules, part 15. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference that may be received, including interference that may cause undesired
operation.
Notice: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at the user’s expense.
Warning: Changes or modifications to this device not expressly approved by InterMetro Industries Corporation could void the
user’s authority to operate this equipment.
Shielded cables must be used with this unit to ensure compliance with the FCC Class A limits.
Industry Canada:
This class A digital apparatus meets all requirements of the Canadian Interface Causing Equipment Regulations. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Regulatory Compliance
This system was tested and complies with UL 60601-1, CAN/CSA C22.22 No.601.1 and IEC/EN 60601-1-1 medical safety
standards.