MovinCool Office Pro 63 Service Manual - Manual (Page 48)

Repair Section
48
8.3 Removal of Electrical Parts
(1) Control box
1) Remove nine (9) screws from service panel. (See page 46.)
2) Remove electrical parts.
- Relay: Remove four (4) screws from control box.
- Reverse phase protector: Pull out reverse phase protector from terminal block.
- Terminal block: Remove four (4) screws from control box.
- Terminal block (signal connection): Remove two (2) screws from control box.
- Terminal block (reverse phase protector): Remove two (2) screws from control box.
- Capacitor: Remove two (2) screws from control box.
- Fuse holder : Remove one (1) screw form control box.
I001960
TB2
FUSE 25A
TB1
G
Terminal Block
(Signal Connection)
Terminal Block
Relay Board Fuse
Relay
Relay Board
Dip Switch
Fuse Holder
Fuse
Fan Capacitor
(Condenser)
Fan Capacitor
(Evaporator)
Terminal Block
(Reverse Phase Protector)
Reverse Phase Protector