Reassembly, 1 removal of unit, 2 compressor mounting – MovinCool Office Pro 63 Service Manual User Manual
Page 74: 3 blower assembly, Removal of unit, Compressor mounting, Blower assembly
Repair Section
74
10. REASSEMBLY
10.1 Removal of Unit
• Reassemble the unit in the reverse order of removal. Described below are the parts that require
special care in reassembling the unit. Perform all wiring or rewiring as referenced in the wiring
diagram.
10.2 Compressor Mounting
• Mount the compressor on the frame, using
cushions, steel collars, spring washers, plate
washers and nuts.
10.3 Blower Assembly
1) Install blower fan for evaporator. Allow a
clearance of 0.12 in (3 mm) (minimum) on each
side of the evaporator fan.
CAUTION
• Tightening torque:
- 10.84 ± 2.17 ft•lbf (15 ± 2.7 N•m)
2) Install blower fan for condenser. Allow a
clearance of 0.12 in (3 mm) (minimum) on each
side of the condenser fan.
CAUTION
• Tightening torque:
- 10.84 ± 2.17 ft•lbf (15 ± 2.7 N•m)
I001818
Nut
Spring Washer
Steel Collar
Cushion
Plate Washer
I002229
Min 0.12 in
(3 mm)
Min 0.12 in
(3 mm)
<Evaporator Blower Assy>
I001947
Min
0.12 in (3 mm)
Min
0.12 in (3 mm)
<Condenser Blower Assy>