ONICON F-2600 - Manual (Page 53)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-2600 & F-2700 Vortex Flow Meter Manual 02/15 - 0808-7 / 19204 Page 53
SECTION 3: OPERATING INSTRUCTIONS
After installing the vortex flow meter, you are ready to begin operation. The sections in this chapter
explain the display/keypad commands, meter start-up and programming. The meter is ready to operate
at start-up without any special programming. To enter parameters and system settings unique to your
operation, see the following pages for instructions on using the set-up menus.
3.1 FLOW METER DISPLAY/KEYPAD
The flow meter’s digital electronics allow you to set, adjust
and monitor system parameters and performance. A full range
of commands are available through the display/keypad. The
LCD display gives 2 x 16 characters for flow monitoring and
programming. The six push-buttons can be operated with the
enclosure cover removed. Or, the explosion proof cover can
remain in place and the keypad operated with a hand-held
magnet positioned at the side of the enclosure as shown in the
illustration at the left.
Figure 49. Flow Meter Display/Keypad
From the Run Mode, the ENTER key allows access
to the Set-up Menus (through a password screen).
Within the Set-up Menus (through a password
screen). Within the Set-up Menus, pressing ENTER
activates the current field. To set new parameters,
press the ENTER key until an underline cursor
appears. Use the ⇑ ⇓ ⇐ ⇒ keys to select new
parameters. Press ENTER to continue. (If change
is not allowed, ENTER has no effect.) All outputs
are disabled when using the Set-up Menus.
The EXIT key is active within the Set-up Menus.
When using a Set-up Menu, EXIT returns you to
the Run Mode. If you are changing a parameter
and make a mistake, EXIT allows you to start over.
The ⇑ ⇓ ⇐ ⇒ keys advance through each screen
of the current menu. When changing a system
parameter, all ⇑ ⇓ ⇐ ⇒ keys are available to enter
new parameters.