OnLine Power Protector 3 - Manual (Page 24)

OnLine Power
3-3
Front
Forklift Forks
Each model of the Protector 3 is designed to supply a maximum load
which is determined by its kVA (1000’s of volt-amperes) and kW rating. It
is very important that the load is within the rating of this Protector to
ensure that the connected loads will be properly supported.
Each electrical device to be powered by the Protector 3 should have a
specification sheet attached to it, which specifies the amount of power it
requires. In addition, this information should be listed in the manual
supplied with each piece of equipment. The device’s nameplate should
also list the electrical requirements of the device.
The total load to be powered by the Protector 3 must not exceed its kVA
rating. If the total load is exceeded, the Protector monitoring will sense an
overload condition and a summary alarm will occur.
3.1.5 Pre-Installation
All customer connections are brought through knockouts located on the top or on the sides of the unit. The
Protector 3 consists of one electronics and one or more battery cabinets. Before unpacking the equipment,
inspect the exterior, the shipping container, and the equipment itself for damage that may have occurred
during transit. If the shipping container or equipment itself shows evidence of damage, note the damage on
the receiving document before signing for receipt of the equipment. Damage claims should be filed directly
with the carrier.
3.2 EQUIPMENT UNPACKING
Remove the equipment from the shipping
carton. Since the Protector is designed for
pad mounting installations, there are no
casters. It is suggested that a forklift be used
to remove the Protector from its shipping
pallet. See illustration 3-2 for the location of
forklift slot.
ILLUSTRATION 3-2: FORKLIFTING
Danger!
EXERCISE EXTREME CARE WHEN HANDLING UPS AND BATTERY
CABINETS TO AVOID EQUIPMENT DAMAGE OR INJURY TO PERSONNEL.
CABINETS WEIGH SEVERAL HUNDRED POUNDS. TEST LIFT AND
BALANCE THE CABINETS BEFORE MOVING. MAINTAIN MINIMUM TILT
FROM VERTICAL AT ALL TIMES. THE BOTTOM STRUCTURE WILL
SUPPORT THE UNIT ONLY IF THE FORKLIFT FORKS ARE COMPLETELY
UNDERNEATH THE UNIT.
Caution