OnLine Power Protector 3 - Manual (Page 41)

OnLine Power
6-2
6.1 Optional External Maintenance Bypass Switch – P/N 3000-044 thru -056
ILLUSTRATION 6-1: EXTERNAL MAINTENANCE BYPASS SWITCH DIAGRAM
6.1.1 Installation
Allow front access to the MBS box at all times for maintenance and servicing. Electrical codes require that the MBS
box be installed with no less than 3 feet at the front of the cabinet. Side and rear panels do not require service
clearance, however side vents must not be blocked.
Refer to Section 3.1, Site Planning and Preparation
Verify the following connections have been made per wiring diagrams: 6001-032-11, 6001-032-12, and
specific application related sheets.
Danger!
ALL POWER CONNECTIONS MUST BE COMPLETED BY A LICENSED
ELECTRICIAN WHO IS EXPERIENCED IN WIRING THIS TYPE OF EQUIPMENT.
WIRING MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE
NATIONAL AND LOCAL ELECTRICAL CODES. IMPROPER WIRING MAY
CAUSE DEATH, INJURY, EXPLOSION, FIRE OR DAMAGE TO THE
EQUIPMENT. VERIFY THAT ALL INCOMING HIGH AND LOW VOLTAGE
POWER CIRCUITS ARE DE-ENERGIZED AND LOCKED OUT BEFORE
INSTALLING CABLES OR MAKING ANY ELECTRICAL CONNECTIONS.