OnLine Power Protector 3 - Manual (Page 87)

OnLine Power
A-1
APPENDIX A - SPECIFICATIONS
Specifications for KVA, 0.8pf Units
POWER RATING (KVA/KW) 10/8 15/12 20/16 25/20 30/24 40/32 50/40 62.5/50
INPUT and OUTPUT
INPUT VOLTAGE (VAC) Three Phase, 4-Wire plus Ground, 208Y/120 or 480Y/277 VAC (-20% to +15%)
OUTPUT VOLTAGE (VAC) Three Phase, 4-Wire plus Ground, 208Y/120 or 480Y/277 VAC
OUTPUT FREQUENCY (Hz) 60 Hz +0.5 Hz
VOLTAGE REGULATION +/-3%, Regulated within CBEMA curve
OUTPUT WAVE FORM Sine-Wave <5% THD.
EFFICIENCY Minimum 90%
CREST FACTOR 3 to 1 Typical
SURGE PROTECTION The UPS will protect itself and the load against surges as defined in ANSI/IEEE C62.41 Categories A and B.
ISOLATION Complete from line. Output neutral bonded to ground
NOISE ISOLATION -120 dB Common-Mode; -60 kB Transverse-Mode
BATTERY Sealed maintenance-free (AGM) battery
RECHARGE CURRENT Conforms to UL Standards
EXTERNAL BATTERY Provisions for hardwire connection of optional external battery cabinets or DC source.
BATTERY
BATTERY RUN TIME Consult OnLine Power
BATTERY TYPE Sealed, Maintenance-Free, AGM, VRLA type
NOMINAL BATTERY VOLTAGE 192 VDC 192 VDC 192 VDC 288 VDC 288 VDC 312 VDC 552 VDC 552 VDC
OVERCURRENT PROTECTION Circuit Breaker
PACKAGING Batteries not housed in Same Enclosure as electronic (See Table 2-2)