Orion System VAV II Controller v.1 - Manual (Page 38)

VAV/CAV CONTROLLER STATUS
VAV/CAV/MUA Operator Interface SD 38
Status Screen Instructions
From any menu screen, press
<STATUS>
. The Unit Selection Screen,
shown below, will appear requesting that you enter the unit ID number.
Unit Selection*00*
Enter Unit ID#
Selected ID#: XXXX
Enter the correct unit ID number of the Unit Controller you want to view
Status for and press
<ENTER>
. Once communication is established,
the *00* message will go away. Then press <

> . You will then see
Status Screen #1. Press
<ENTER>
to save entered data and press
<  >
to scroll through the screens.
NOTE:
If the *00* remains, it indicates a communication failure
to the controller.
VAV/CAV Status Screen Index
Status Screen #1 HVAC Mode
Status Screen #2 Cooling/Heating/Economizer Status
Status Screen #3 Current Controlling Temperature and
Cooling and Heating Setpoints
Status Screen #4 H/C Demand, Space Temperature &
CO
2
Level
Status Screen #5 Current Outdoor Air Temperature
and Humidistat
VAV/CAV Status Screen Index
Status Screen #6 Current Supply Air Temperature,
Return Air Temperature, and Active
Supply Air Temperature Setpoint
Status Screen #7 Current Static Pressure and Current
Fan VFD Signal Percentage
and Economizer Percentage
Status Screen #8 Current Relief Pressure and Current
Relief Fan VFD Signal
Status Screen #9 MODGAS Output Percentage &
MHGRV Output Percentage
Status Screens #10-30 Supply Fan and Other Relays
Status Screen #31 No Alarms! or Alarms Present
Status Screen #32 Bad Space Temperature, Fan Proving,
Mechanical Cool Alarm
Status Screen #33 Mechanical Heat Alarm, Dirty Filter,
High Control Temperature
Status Screen #34 Low Control Temperature