Orion System VAV II Controller v.1 - Manual (Page 66)

APPENDIX A - SAVE, LOAD, COPY SETPOINTS
VAV/CAV/MUA Operator Interface SD
66
Modular Service Tool Instructions
From any menu screen, press
<BALANCE-TEST>
. The Unit Selection
Screen will appear requesting that you enter the unit ID number.
Unit Selection*00*
Enter Unit ID#
Selected ID#: XXXX
Enter the network unit ID for the controller you want to save the setpoints
from. Example, ‘102’ for Loop 1 / Unit 2. Then press
<ENTER> . Once
communication is established, the *00* message will go away. After a
brief pause, press
<

>
to get to the Balance - Test Screen shown below.
Outputs Force
Para Blocks
Save/Copy/Restore
Scroll down to the ‘Save/Copy/Restore’ option and press
<ENTER>
.
This will take you to the Save Setpoints screen.
System Manager SD Instructions
From any Main screen, press
<SETPOINTS>
. The screen below will
appear because this option requires passcode clearance. Only a Level 2
passcode can change setpoints.
THIS ACTION REQUIRES
PASSCODE CLEARANCE
Enter Passcode: XXXX
If the correct passcode was entered, the Unit Selection Screen will be
displayed.
Unit Selection*00*
Enter Unit ID#
Selected ID#: XXXX
Enter the Unit ID of the controller you wish to change schedules for
and press
<ENTER>
. Once communication is established, the *00*
message will go away. Then press <

> .
NOTE: If the *00* remains, it indicates a communication
failure to the controller.
The following screen will be displayed:
Change Setpoints
Configure Unit
Save/Copy/Restore
Scroll down to the ‘Save/Copy/Restore’ option and press
<ENTER>
.
This will take you to the Save Setpoints screen.
Save Setpoints - Network Mode
From the Save Setpoints Screen shown below:
Save Setpoints
Press Enter To Save
Press <ENTER> and a setpoint fi le will be saved to the SD card. You
will receive a message that the save was successful. This fi le is specifi c
to this controller on this loop.
Saving & Copying Setpoints