RJS Inspector D4000 SP (FIRMWARE version A.06 and Later) - Manual (Page 23)

Operator
’s Guide
Inspector D4000
™ Laser SP
002-5572 RJS, Minneapolis, MN 15
Scans/Analysis
Single
From this screen you may choose the number of scans
(from 1 (single) to 10 or continuous) to be used in the
analysis. When set to continuous the D4000 will scan
and grade bar codes until the Laser trigger is released,
then the Continuous Results screen will be displayed:
(See 8.5 Continuous Mode)
The last selection is Comparison Mode:
Comparison Mode
Off
When Comparison Mode is On, the first bar code
scanned after turning Comparison Mode On will be
saved as the Master bar code. All bar codes scanned
will be compared to the Master bar code and if the
encoded data does not match then a No Match error
will be displayed.
(See 7.2, Comparison Mode)
Note:
When all Setup selections have been made, the RJS
Inspector D4000 will navigate back to the Main Menu
automatically.
All setup parameters are retained in non-volatile
memory and will be saved until changed by you
—
even
if the power is turned off.