RJS Inspector D4000 SP (FIRMWARE version A.06 and Later) - Manual (Page 42)

Appendix B Operator
’s Guide
RJS, Minneapolis, MN 002-5572
Table B-2 (Parameters Checked for Each Symbology)
Symbology Ratio ICG Data
Character Mod
Check Tolerance
AIAG B-1 2.0-3.2 .5X-8X STD CODE 39 N/A ((12R-8)/81)X
AIAG B-3 B-4 B-5 2.8-3.2 .5X-8X
$/+% Not
Allowed
N/A ((12R-8)/81)X
LOGMARS 2.0-3.0 .5X-8X STD CODE 39 N/A ((12R-8)/81)X
CODE 3 OF 9 2.0-3.0 .5X-8X STD CODE 39 N/A ((12R-8)/81)X
3 OF 9 W/43 2.0-3.0 .5X-8X
STD CODE 39
4 CHARS Min
MOD 43 ((12R-8)/81)X
HIBC 3 OF 9 2.0-3.0 .5X-8X
STD CODE 39
Min 4 CHARS
1ST. = "+"
MOD 43 ((12R-8)/81)X
INTERLVD 2 OF 5 2.0-3.0 N/A N/A N/A ((18R-1)/80)X
CASE CODE 2.0-3.0 N/A
14 or 18 Data
Chars Only
MOD 10 ((18R-1)/80)X
I 2 of 5 with check
digit
2.0 N/A Min 4 Data Chars MOD 10 ((18R-1)/80)X
CODE 128 N/A N/A N/A
MOD
103
.35X
CASE CODE 128 N/A N/A
<Fnc1> with AI
00 and 18 Data
Char
Or <Fnc1> with
AI 01 and 14
data characters
Application Mod
Check Mod 10
Mod 103
.35X
UPC/EAN N/A N/A N/A MOD 10 See Note 1
Notes:

X = X dimension

R = Ratio in the calculations

Tolerance is expressed as a fraction of the X dimension

See Appendix D for Quiet Zone Analysis descriptions.