Smart Avi SignagePro - Manual (Page 99)

9. Update clients firmware via USB 95
(c) 2010 SmartAVI
figure 10.0.4
4. After the USB writing is done, bring the USB to the SignagePro client and insert into the
USB port.
5. Boot the client and hit DELETE on the keyboard, which is attached to client, serveral times
to enter into the BIOS. Once you are in the BIOS, tab over to the “Boot” menu to make sure
your USB will be the first device to boot from and save changes.
Reboot.
6. Once rebooting the client, the unit should recognize your USB and it should automatically
start writing the Linux SignagePro firmware onto the internal drive. This will take about 1-
3mins.
Once the writing has finished and rebooted, the client should now be ready.