Super Systems 9210 Series - Manual (Page 16)

M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 16 of 16
The Manual Event Control page allows the operator to turn on Output events in place of running a recipe to
turn the Event on.
The Zone/Load TC Setup page allows the operator to select the thermocouples to use in the recipe for
guaranteeing the Furnace temperature.
The Shutdown selection allows for the Advantech display to be turned off. The “Do you want to Shutdown
the Model 9210 ” screen pops up when you press the “shutdown” key. Two responses are possible “Yes”
or “No”. When you shut-down the ADVANTECH interface, the SERIES 9210 controller is still functioning.
You can monitor it by connecting the ETHERNET connection to a laptop computer, using Internet Explorer,
and assigning a legitimate IP address.
NOTE: Shutting down the ADVANTECH (Operator Interface) does not “turn-off” the Series 9210. The
“shut-down” procedure must be done to remove the “flashcard” .
“Yes” shows you a typical computer screen with the “start” button in the bottom left-hand corner. You can
now turn the power off to the operator interface without upsetting any of the settings. The “No” response
returns you to the initial status screen.