Super Systems 9210 Series - Manual (Page 36)

M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 36 of 36
The next screen is the Span Output 2 screen. This
screen will allow the user to set the span value for
Output 2. Measured at terminals 26(-) and 25(+) for
this step. The progress bar at the bottom of the
screen will display the calibration progress.
The next screen indicates that the calibration process is complete.
Full Calibration
This screen is used by SSi personnel, and it is a longer version of the
User Calibration menu.
Set Menu Security
This menu allows the user to set the security level for all of the menu screens to one of three levels:
1. Operator – Lowest Level, No Pass code Required
2. Supervisor – Middle Level, Level 1 Pass code Required
3. Administrator – Highest Level, Level 2 Pass code Required.
The menu items with security levels are:
Menu Item Security Level
Program Edit Supervisor
Auxiliary Instruments Operator
Auxiliary Analog Input Operator
Shutdown Operator
9210 Date and Time Supervisor
Slave Communications Status Supervisor
Manual Event Control
Supervisor
PID Loop Setup Administrator
Event Run Program Setup Administrator
Zone/Load TC Setup Administrator
Port Setup Administrator
Instrument Setup Administrator
Zone Assignments Administrator
Furnace Setup Administrator
Default Wait Limits Administrator
Furnace Name Administrator
Alarm Setup Administrator
Relay Assignments Administrator
Relay Setpoints Administrator
Analog Input Setup Administrator
Analog Output Setup Administrator
Passcode and Alarm Administrator
IP Address Administrator
Event Control Administrator
Valve Configuration Administrator
Valve Setup Administrator
User Calibration Administrator
Edit
Span Output 2
Calibrate
<-- Back Skip Next --> DONE
Enter measured output current (mA)