Affixing a generic label – H3C Technologies H3C S12500 Series Switches User Manual
Page 150
Advertising
140
Figure 107 Affixing a label
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure the
label is facing out, as shown in
.
Figure 108 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For more
information, see "
Affixing a label to a signal cable
." For the example of affixed labels, see
.
TO:
B03
–
48V2
Advertising