H3C Technologies H3C S12500 Series Switches - Manual (Page 82)

72
Field Remarks
Voltage high The voltage is high.
Voltage low The voltage is low.
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum
error
Transceiver information checksum error.
Transceiver type and port
configuration mismatch
The type of the transceiver module does not match the port configuration.
Transceiver type not
supported by port hardware The port does not support this type of transceiver modules.
XFP
RX loss of signal Received signals are lost.
RX not ready The receiving status is not ready
RX CDR loss of lock Receiving CDR loss of lock.
TX fault Transmission error.
TX not ready The transmission status is ready.
TX CDR loss of lock Transmission CDR loss of lock.
Module not ready The module is not ready.
APD supply fault Avalanche Photo Diode (APD) supply error.
TEC fault Thermoelectric Cooler (TEC) error.
Wavelength unlocked Wavelength loss of lock.
RX power high The received optical power is high.
RX power low The received optical power is low.
TX power high The transmitted optical power is high.
TX power low The transmitted optical power is low.
TX bias high The transmitted bias current is high.
TX bias low The transmitted bias current is low.
Temp high The temperature is high.
Temp low The temperature is low.
Voltage high The voltage is high.
Voltage low The voltage is low.
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum
error
Transceiver information checksum error
Transceiver type and port
configuration mismatch
The type of the transceiver module does not match the port configuration.
Transceiver type not
supported by port hardware The port does not support this type of transceiver modules.