Configuration procedure, Displaying the operating state of fans – H3C Technologies H3C S12500 Series Switches User Manual
Page 75
65
•
If a port is automatically shut down due to hardware failure protection, its status displayed with the
display interface command is Protect DOWN. To bring up the port, use the undo shutdown
command on the port.
•
If a card is isolated or its software is not allowed to be loaded due to hardware failure fix operations,
you can plug out the card and then plug it in to recover the card status.
•
After configuring in-service diagnosis and failure protection, you can use the display
hardware-failure-detection command to check the running information of the feature.
Configuration procedure
To configure in-service hardware failure diagnosis and failure protection:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable in-service hardware
failure detection and
configure fix actions taken in
case of hardware failures.
hardware-failure-detection { chip |
board | forwarding } { off |
warning | reset | isolate }
Fix actions for hardware failures:
•
off—Takes no action.
•
warning—Sends warning
messages.
•
reset—Resets the failed card.
•
isolate—Shuts down the failed
port, isolates the failed card,
prohibits the failed card from
loaded, or powers off the failed
card to reduce the impact of the
failure to the system.
By default, the fix action taken for
all hardware failures is warning.
3.
Enable hardware failure
protection for aggregation
groups.
hardware-failure-protection
aggregation
Optional.
Disabled by default.
This command is effective only
when the fix action is configured as
isolate.
4.
Enter Ethernet interface view. interface interface-type
interface-number
N/A
5.
Configure hardware failure
protection for the port.
hardware-failure-protection
auto-down
Optional.
Disabled by default.
This command is effective only
when the fix action is configured as
isolate.
Displaying the operating state of fans
Use the display fan verbose command to display the operating state of fans on your switch.
•
In standalone mode:
# Display detailed information about all fans on the switch.