H3C Technologies H3C SecPath F1000-E - Manual (Page 118)

110
Step Command Remarks
2. Enter user interface view.
user-interface { first-num1
[ last-num1 ] | { console | vty }
first-num2 [ last-num2 ] }
N/A
3. Specify the scheme
authentication mode.
authentication-mode scheme
By default, the authentication
mode for VTY users is password,
and no authentication is needed
for console users.
4. Return to system view. quit N/A
5. Configure the authentication
mode for SSH users as
password.
For more information, see System
Management and Maintenance
Configuration Guide.
This task is required only for SSH
users who are required to provide
their usernames and passwords for
authentication.
6. Configure the user privilege
level by using the AAA
module.
• To use local authentication:
a. Use the local-user
command to create a
local user and enter local
user view.
b. Use the level keyword in
the
authorization-attribute
command to configure the
user privilege level.
• To use remote authentication
(RADIUS, HWTACACS, or
LDAP):
Configure the user privilege
level on the authentication
server
User either approach.
For local authentication, if you do
not configure the user privilege
level, the user privilege level is 0.
For remote authentication, if you
do not configure the user privilege
level, the user privilege level
depends on the default
configuration of the authentication
server.
For more information about the
local-user and
authorization-attribute commands,
see Access Control Command
Reference.
For example:
# Configure the device to use local authentication for Telnet users on VTY 1 and set the user privilege
level to 3.
<Sysname> system-view
[Sysname] user-interface vty 1
[Sysname-ui-vty1] authentication-mode scheme
[Sysname-ui-vty1] quit
[Sysname] local-user test
[Sysname-luser-test] password cipher 123
[Sysname-luser-test] service-type telnet
When users Telnet to the device through VTY 1, they must enter username test and password 12345678.
After passing the authentication, the users can only use level-0 commands of level 0.
# Assign commands of levels 0 through 3 to the users.
[Sysname-luser-test] authorization-attribute level 3
Configuring the user privilege level directly on a user interface
To configure the user privilege level directly on a user interface that uses the scheme authentication mode: