Performing basic configuration, Launching the basic configuration wizard – H3C Technologies H3C SecPath F1000-E User Manual
Page 63
55
Performing basic configuration
You can perform the following basic configuration in the web interface or at the CLI:
•
System name and user password. Modify the system name and the password of the current user. For
more information, see "Managing the device" and "Managing users."
•
Service management. Specify whether to enable the services like FTP, telnet, HTTP, and HTTPS, and
set port numbers for HTTP and HTTPS. For more information, see Access Control Configuration
Guide.
•
Interface IP address. Configure IP addresses for Layer 3 Ethernet interfaces and VLAN interfaces.
For more information, see Network Management Configuration Guide.
•
NAT. Configure dynamic NAT, internal server translation, and related parameters. For more
information, see NAT and ALG Configuration Guide.
•
Zone. Configure a zone to perform interface or IP address-based security policy control. For more
information, see Access Control Configuration Guide.
Performing basic configuration in the web interface
This section describes the fast configuration by using the basic configuration wizard.
Launching the basic configuration wizard
1.
Select Wizard from the navigation tree to enter the Configuration Wizard page.
2.
Click the Basic Device Information hyperlink to enter the first page of the basic configuration page.