H3C Technologies H3C SecPath F1000-E - Manual (Page 67)

59
Item Description
HTTPS
Specify whether to enable HTTPS on the firewall, and set the HTTPS port number.
Disabled by default.
IMPORTANT:
• If the current user logged in to the web interface through HTTPS, disabling HTTPS
or modifying the HTTPS port number will result in disconnection with the firewall.
Therefore, perform the operation with caution.
• When you modify a port number, make sure that the port number is not used by
another service.
• By default, HTTPS uses the PKI domain default. If this PKI domain does not exist, the
system will prompt you for it when the configuration wizard is completed; however,
this will not affect the execution of other configurations.
Configuring an IP address for an interface
1. Click Next on the service management configuration page to enter the interface IP address
configuration page.
The table lists the IP address configuration information for all Layer 3 Ethernet interfaces and VLAN
interfaces.
Figure 38 Basic configuration wizard—4/6 (interface IP address configuration)
2. Click the link for any interface to perform IP address configuration as described in Table 10 .