Configuring nat – H3C Technologies H3C SecPath F1000-E User Manual
Page 68
60
Table 10 Configuration items
Item Description
IP Configuration
Set the approach for obtaining the IP address:
•
None—The IP address of the interface is not specified,
that is, the interface has no IP address.
•
Static Address—Specify the IP address for the interface
manually; if you select this item, you need to specify
both the IP address and the mask.
•
DHCP—The interface obtains an IP address
automatically through the DHCP protocol.
•
Do not change—The IP address of the interface does
not change.
IMPORTANT:
Modification to the
interface IP address will
result in disconnection
with the firewall, so
make changes with
caution.
IP Address
If you select Stack Address as the approach for obtaining
the IP address, you need to set the interface IP address and
network mask.
Mask
Configuring NAT
1.
Click Next on the interface IP address configuration page to enter the NAT configuration page.
Figure 39 Basic configuration wizard—5/6 (NAT configuration)
2.
Complete NAT configuration as described in