H3C Technologies H3C SecPath F1000-E - Manual (Page 61)

53
Displaying and maintaining ACSEI server and client
Task Command Remarks
On the network device:
Display ACSEI client summary.
display acsei client summary
[ client-id ]
Available in any view
Display ACSEI client information.
display acsei client info
[ client-id ]
Available in any view
On the firewall module:
Display ACSEI client information. display acsei-client information Available in any view
Display current ACSEI client state. display acsei-client status Available in any view
Example of monitoring and managing the firewall
module from the network device
Network requirements
A firewall module is installed in slot 3 of the network device to detect the traffic passing the network
device. The internal interface Ten-GigabitEthernet 3/0/1 on the network device is connected to the
internal interface Ten-GigabitEthernet0/0 on the firewall module.
The network device redirects received traffic to the firewall module. The firewall module processes the
traffic based on the configured security policy, and redirects permitted traffic to the network device for
forwarding.
Configure the network device and firewall module so that you can log in to and restart the firewall
module from the network device. Configure the clock synchronization timer as 10 minutes, and configure
the monitoring timer as 10 seconds.
Figure 34 Network diagram
Configuration procedure
This example uses a switch. The configuration on a router is the same.
1. Log in to the firewall module from the network device:
# Configure the AUX user interface of the firewall module.
<FW card> system-view
[FW card] user-interface aux 0
[FW card-ui-aux0] authentication-mode none
[FW card-ui-aux0] user privilege level 3